Rattling sound

Started by moto, September 21, 2026, 08:33:17 AM

Previous topic - Next topic

moto

Quote from: Troll on September 24, 2026, 07:42:36 AM

Mine rattles louder with 10-40, so I always run 20-50. Transmission is quieter with 20-50, too. I don't like synthetic oils (many reasons, too many to list here) so I use Valvoline conventional 20-50 motorcycle oil. My 1500 has 249,500 Km on it.

I use also 20-50 oil, maybe sounds little disappear but rattling noise not entirely.

It can only be heard while idling—for example, at traffic lights—but the sound disappears when you press the clutch all the way down and driving its not hear anything

Let the good times roll

Troll

Mine rattles louder with 10-40, so I always run 20-50. Transmission is quieter with 20-50, too. I don't like synthetic oils (many reasons, too many to list here) so I use Valvoline conventional 20-50 motorcycle oil. My 1500 has 249,500 Km on it.

Recovering H-D owner...W-650 Cafe' No excuses...Ride it or sell it to someone who will!

moto

#5
Quote from: Troll on September 23, 2026, 07:37:23 AM

Clutch basket wear. Mine has done it for years. Most noticeable when it's cold. Pretty much goes away after the engine is up to temp, but not completely gone. I have 155,000 miles on the bike, as of right now.

Well, you think that I can drive with that sound, so engine dont break ? I have 47 000km mileage.

I use 20w-50 mineral oil.  Could switching to a different type of oil help, 10w-40 perhaps ?

Let the good times roll

Troll

Clutch basket wear. Mine has done it for years. Most noticeable when it's cold. Pretty much goes away after the engine is up to temp, but not completely gone. I have 155,000 miles on the bike, as of right now.

Agree Agree x 1 View List
Recovering H-D owner...W-650 Cafe' No excuses...Ride it or sell it to someone who will!

drifter-paul

#3

1 - Crack the throttle (like a hoon) in 3rd at about 60K/35MPH . If it takes a second for acceleration to catch up - you have worn clutch plates .

2 - Check this post . rear spark plug on right side of motorcycle, forward spark plug on left . You will see a recessed ("23 mm") hex plug . remove spark plug and check for groove in each aluminum tunnel . This will tell you the cam chains are worn and rubbing thru .

3 - If mechanically minded, you can find articles in this forum to replace the Cam chain tensioners -  and replace the convex/ concave plates in the clutch - these wear first -   otherwise refer previous answer

https://www.vulcandrifterriders.com/forum/index.php/board,124.0.html

Knowledge is knowing a tomato is a fruit, wisdom is not putting it in a fruit salad.

Fab

Hey @moto

If I were you, I'd take the motorcycle to a local mechanic or motorcycle shop and have them listen to the noise.

It might be a minor issue, but it's always better than getting stranded on the side of the road if something breaks down along the way.


moto

There is a rattling sound coming from the right side of the bike at idle, but it disappears when the clutch is pulled in. So, it only occurs at idle or at very low RPMs.
Is this serious? Could the clutch be failing? The transmission works fine, though, and all the gears engage smoothly.

Let the good times roll

SMF spam blocked by CleanTalk