Quote from: Bucko on May 12, 2025, 15:50:28 PMI don't have an 800 but typically, chain drive bikes have left and right index markings on the swing arm near the rear axel to ensure the axel adjustment is the same on both sides of the swing arm (which should ensure the alignment of the front and rear sprockets, in addition to ensuring the rear wheel is in alignment, or parallel to, the centreline of the bike). Not unheard of for those index marks to not be 100% accurate but that would be very atypical.
I defiant did see those and not inly
matched those up but then measured them because of n this forum I saw where they're not always true and you should measure just for good measure. Side note it made me realize my rear rotor wasn't warped albeit worn and the last person to adjust it was off by just the tiniest bit. Gotta take some wins when you can lol

