We limit access by GUESTS to protect our members from spam, hacks and trolls. Please register to gain access to all our resources.
Posted by Tim
- June 02, 2023, 11:55:01 AMWe are privileged to have such wisdom on this site.
Posted by Troll
- May 28, 2023, 18:59:54 PMVERY IMPORTANT QUESTION: Do you hear the fuel pump run for 2 seconds after you turn on the key? After having this happen to mine, I am very suspicious of the older ign. switches. There is a signal wire that runs to the ECM that carries a verifying voltage. It's a very small signal, and is there just to prevent the fuel pump from running if the ign. switch has been bypassed. It's listed as unused, pin # 20, and is in the A terminal block. If the ign. switch fails to send the proper signal to the ECM, the pump will NOT run. There are two wires for the fuel pump. One is B+ and the other is ground. The ECM switches the ground on and off. IF the pump does not run, determine which wire is "hot", and which is ground. Turn on the ign. and ground the wire that is NOT HOT! This should turn on the fuel pump. You can leave the jumper in place and try to start the engine. What you are essentially doing is bypassing the ECM's fuel pump control ckt.
Posted by gwilki
- May 20, 2023, 18:28:29 PMQuote from: lefecious on May 18, 2023, 19:32:17 PMI think I must have spark because when he sprayed the starter fluid it did "run" for like half a second.
If I didn't have spark, it would just crank and not ignite at all, correct?
Sorry, I understood from your first post that it never started. It just "tried to".
Chief has given you excellent information.
In reply to your question, if it ran briefly, clearly some spark is there. I would still check to see if all plugs are firing, though. It's an easy thing to check and you have nothing to lose.
Posted by chief
- May 19, 2023, 19:14:27 PMQuote from: lefecious on May 18, 2023, 19:33:04 PMLooks like I need to do some research. I don't even know how to check for efi codes. Thanks for the direction though! At least now I have something to check.
Here is some info to help:
This is the main area for electrical and electronic mods/tips.
In there is a link to the Mods index for Electrical The page you are looking for is the ECU Faults write-up.https://www.vulcandrifterriders.com/ECUFaultCodes.html
I did the long version of this to help direct other members who read this in the future.
Cheers.
Posted by lefecious
- May 18, 2023, 19:33:04 PMQuote from: chief on May 18, 2023, 12:44:36 PMAre you getting any efi error codes?
Looks like I need to do some research. I don't even know how to check for efi codes. Thanks for the direction though! At least now I have something to check.
Posted by lefecious
- May 18, 2023, 19:32:17 PMQuote from: gwilki on May 18, 2023, 06:42:57 AMDo you have spark?
I think I must have spark because when he sprayed the starter fluid it did "run" for like half a second.
If I didn't have spark, it would just crank and not ignite at all, correct?
Posted by chief
- May 18, 2023, 12:44:36 PMAre you getting any efi error codes?
Posted by gwilki
- May 18, 2023, 06:42:57 AMDo you have spark?
Posted by lefecious
- May 17, 2023, 16:05:02 PMHi all, drifter 1500 sat for years and I'm trying to resurrect it
So far I've cleaned out the fuel tank with vinegar, tested and cleaned the injectors, and replaced the fuel pump and battery.
Tried you start it but it cranks but won't catch idle.
I had a buddy spray some starter fluid into the air intake and it sounded like it was going to start. But only for half a second.
What else can I try?