Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by pcarrell
 - July 16, 2014, 17:54:48 PM

Easy mistake to make!

Posted by DrifteRizzo
 - July 16, 2014, 15:07:58 PM

Think I may have the saddlebag supports reversed...Doh!   That would explain the clearance issue.  If it doesn't I'll drop some photos.
Thanks,

Rizzo
Posted by pcarrell
 - July 16, 2014, 12:43:58 PM

The black bike at the top of this page is mine, and it shows the solo and 2up setups.  There are 2 bolts on each side, and one is a little longer then the other.  I have to switch the front and back bolts between the setups, with the long bolt being in the rear on the 2up setup.  Hope this helps!

http://www.vulcandrifterriders.com/oemsbsetup.html

Posted by jmbo
 - July 16, 2014, 11:06:44 AM

Not sure which mounting bolts you are referring.  Can you send a photo?

Posted by DrifteRizzo
 - July 16, 2014, 09:48:08 AM

So, I am having some trouble mounting my saddle bags with the 2-up seat.  I mounted the supports and the bags, but when I try and put the seat back on it doesn't clear the bolts for the support brackets.  Did the PO swap out bolts?  what I have is an 18mm bolt (nothing fancy) with a standard hex shaped head (which is where the clearance issue arises).
Any help would be great!

Thanks,

Rizzo

SMF spam blocked by CleanTalk