Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by cochise
 - July 27, 2010, 22:50:39 PM

There is a tool called a thread guage. You line up the threads on the fitting with the correct guage, and its printed on the side what size and number of threads are. They usually come in a tap and die kit, or can be bought separetly.

Posted by Master Gates
 - July 25, 2010, 13:24:18 PM

Does anyone know the size of the grease fittings used on the 800?  There are three of them under the bike for the suspension and I am looking to replace them.  Went to lube it and the grease was coming back out of the fitting after I took the grease gun off, then continued to drip a bit.  Must be some dirt in there or something that is not allowing that ball to seal off the opening properly.  I dont want to mess things up ruin any threads :)

TIA

SMF spam blocked by CleanTalk