Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by Troll
 - January 31, 2014, 08:38:41 AM

  I put a set of those barrel style grips on a couple of years ago. They were made to fit a Harley (any surprise?) I found that the left one when right on without issue, but the throttle tube was another thing, entirely. The tube that was in the isogrips that were on the bike to begin with (and I hated on sight) was smaller in diameter than the H-D grip, and the diameter of the H-D throttle tube was bigger than the hole in the switch pod on the bike. I decided to mod the tube, rather than the bike. I wound up wrapping the tube with good old fashioned friction tape to take up the extra space and then used the grip cement to hold the whole mess together...It's been holding for around 30,000 miles, so I guess it worked.

Posted by 49Reo
 - January 30, 2014, 22:55:08 PM

Good luck with that!!! I hoped he would get me a Drifter Shifter for MY birthday, not even so much as a lousy card...... ;D

Posted by Cotton Mouth
 - January 30, 2014, 22:52:46 PM
Quote from: CDNRatMan on January 30, 2014, 22:44:03 PM

I know on my 800 I just left that there and slid the Kuryakyn ISO grips right over that and don't even know it is there.

Guess I'm not as lucky as you!  ;D    These rubber grips will fit and look better if I can remove the piece.

Hope Ratman will get me a shiny new rare Roadhouse exhaust system for my birthday.

Posted by CDNRatMan
 - January 30, 2014, 22:44:03 PM

  I know on my 800 I just left that there and slid the Kuryakyn ISO grips right over that and don't even know it is there.

Posted by Cotton Mouth
 - January 30, 2014, 22:30:51 PM

Installing some vintage style grips on oem bars.  On left side, can I remove the male threaded piece without cutting / damaging it?  I can't tell if it's threaded in, welded, or pressed.

On the right side, I haven't remove it yet, but I think it's plastic and I will need to just cut it off the throttle tube.

SMF spam blocked by CleanTalk