Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by Anti-hero
 - June 08, 2013, 14:46:43 PM

With kickstand up or down its starts  even in gear...

Posted by Anti-hero
 - June 08, 2013, 14:36:18 PM

It stalls once I let out the clutch... It idles fine in neutral and it idles once in gear with the clutch pulled in... Once I let out(even with a little throttle) it shuts off...

Posted by chief
 - June 08, 2013, 13:56:38 PM

Start again and explain exactly what is happening.

Sit on the bike. Depress the clutch and start the bike. Ensure its in neutral and release the clutch... does it continue to run?

Assuming it does... lift the kickstand, depress the clutch, put the bike in gear... what happens?

Posted by waltervl
 - June 08, 2013, 08:22:32 AM

There is also a clutch switch and a neutral switch. Search on the forum to get more information or wait untill a more experienced member helps you with the details. The clutch switch is near the clutch lever at lest. So you could clean the connections and check it.

Posted by Anti-hero
 - June 08, 2013, 01:41:52 AM

So I tried jumping the switch harness with a u joint pin type wire and the bike turned on but didn't read that it was in neutral and it still stalled... ??? Could be something else? Is there a clutch switch? I'm still going to look into the sidestand switch. Bit more but so far I've tried the jumping technique and nada... :/

Posted by Troll
 - June 05, 2013, 18:30:05 PM

Under the left side chrome cover (if you have one), is a bunch of connectors. Here is a diagram that will help you find the side stand wiring harness. It's a 2 wire plug #55 on the diagram. I labeled a couple of other land marks.

Posted by greenbarn
 - June 05, 2013, 15:33:12 PM
Quote from: Anti-hero on June 05, 2013, 15:27:21 PM

Do u mean the switch by the battery? I think that's where the cable leads to...

I believe he's speaking of the kick-stand switch.  Should be on the frame by the kickstand.  Unplug the switch.  Install a jumper wire (u-shaped hair-pin type piece of wire) to connect the wires on the plug end coming from the bike wiring harness (NOT the connection on the switch itself).  Try to start.

If that works, the switch is bad.

This is assuming it's a normally-open switch (i.e. switch is "open" with kickstand down, and closes, making the connection, when the kickstand is put up).  It's unlikely it's normally-closed (EG opposite of normally open)

Posted by Anti-hero
 - June 05, 2013, 15:27:21 PM

Do u mean the switch by the battery? I think that's where the cable leads to...

Posted by Troll
 - June 05, 2013, 08:01:01 AM

The switch side and the harness side of the connector. Jumping the wires on the harness side will bypass the switch, jumping the wires on the switch side will do nothing.

Posted by Anti-hero
 - June 04, 2013, 20:43:42 PM

Stupid question.... But what did youi mean jumping to the harness side?

Posted by chief
 - June 04, 2013, 19:55:00 PM
Quote from: greenbarn on June 04, 2013, 18:20:54 PM

I agree wi/ Troll.  That sounds like it almost has to be the sidestand switch.  Did you put the kick stand up?   ::) just kidding, probly a bad switch.

Not a silly question... i had that problem the first bike i bought with a kickstand switch.
Posted by greenbarn
 - June 04, 2013, 18:20:54 PM
Quote from: Anti-hero on June 04, 2013, 14:48:28 PM

Yea everything fine idls ok and moves around its when I ease out of the clutch..

I agree wi/ Troll.  That sounds like it almost has to be the sidestand switch.  Did you put the kick stand up?   ::) just kidding, probly a bad switch.

Posted by Troll
 - June 04, 2013, 14:50:19 PM

I'd try jumping across the side stand switch connector on the harness side, and see what happens.

Posted by Anti-hero
 - June 04, 2013, 14:48:28 PM

Yea everything fine idls ok and moves around its when I ease out of the clutch..

Posted by Troll
 - June 04, 2013, 14:44:25 PM

Ok, let me see if I have this straight...the engine will idle ok, but stalls when you try to get moving from a stop...silly question, but does it roll ok if you push it around? I'm still thinking this is a problem with the sidestand switch......Does it stop as soon as you put it in gear, or when you start to ease out the clutch

SMF spam blocked by CleanTalk