Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by Troll
 - June 04, 2013, 14:50:19 PM

I'd try jumping across the side stand switch connector on the harness side, and see what happens.

Posted by Anti-hero
 - June 04, 2013, 14:48:28 PM

Yea everything fine idls ok and moves around its when I ease out of the clutch..

Posted by Troll
 - June 04, 2013, 14:44:25 PM

Ok, let me see if I have this straight...the engine will idle ok, but stalls when you try to get moving from a stop...silly question, but does it roll ok if you push it around? I'm still thinking this is a problem with the sidestand switch......Does it stop as soon as you put it in gear, or when you start to ease out the clutch

Posted by Anti-hero
 - June 04, 2013, 14:35:25 PM

Well as soon as I try and take off... When I disengage the lever pretty much and even with a little throttle it'll stall out...it goes into gear jus when I take off

Posted by Troll
 - June 04, 2013, 14:00:02 PM

The fuel filter is inside the tank, connected to the pump. Does the engine stop as soon as you put it in gear?

Posted by Anti-hero
 - June 04, 2013, 13:38:03 PM

Can it also be the fuel filter? I actually might be running a lil rich because when I changed the spark plugs I was told they were saturated and they did smell alot like fuel...??

Posted by Troll
 - June 04, 2013, 12:43:33 PM

The wiring diagram and the service manual are not helpful. Shows it's a 2 wire switch, on or off.....There should be a connector under the engine with the two wires in it. I would first try disconnecting it and see if the engine runs, and if it doesn't , jumper across the harness side connector and see what happens. I suspect the two poles must be connected, but there is NO information in the manual....

Posted by Troll
 - June 04, 2013, 12:33:55 PM

If the engine runs until you pop it in gear, and then stops..the sidestand switch is probably the culprit. I'll look at the wiring diagram for it and get back to you.

Posted by Anti-hero
 - June 04, 2013, 10:15:33 AM

Oh I see the cable that runs behind the sidestand? How do I go about this?

Posted by Anti-hero
 - June 04, 2013, 10:06:55 AM

Sidestand switch?

Posted by Troll
 - June 04, 2013, 10:03:35 AM

Sidestand switch? Always hated those stupid things....

Posted by Anti-hero
 - June 04, 2013, 10:01:48 AM

So my bike starts changed the oil and spark plugs on Saturday and it rode fine until this morning... Bike starts and everything but when I go into first gear and I'm about to take off it shuts off... I let warm up and everything but it jus stalls when trying to take off...
Help this is my only ride much help appreciated... Thanks.

SMF spam blocked by CleanTalk