Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by lumper
 - April 06, 2011, 14:54:30 PM

Hi all,
So I want to swap my grips.
I ordered a pair of 1" grips for my bike.
I have flanders 1" black beach bars.
I pulled off my existing grips and measured the bar end to check the diameter.
I foun that the left side diameter was 1" and the inside diameter of the rip is also 1".
When I check the throttle side I find that the grip inside diameter is actualy 1 1/4".
Is that because of the throttle sleeve?
So in other words would a set of grips with a 1" diamter normaly have the throttle side slightly larger?
I just want to make sure the grips I ordered are going to fit.
I can just wait til they arrive and find this out but Ifigured it couldnt hurt to ask and see what you all think.
Thanks for any info.
to be clear the left side outside diameter of the bars is exactly 1", and the right side is 1 1/4", I assume 1" grips will fit but I just need to make sure,
thanks again,
Lump

SMF spam blocked by CleanTalk