Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by greenbarn
 - June 18, 2020, 22:41:01 PM

Did you figure out a way to make the aluminum plates the correct diameter, without the lathe?  Like we talked, a drill press (or even hand drill in a vice) can be made to spin the plates and you can grind them down with a flap wheel on a grinder or something ... lots of ways to skin the cat.

Keep me posted

Posted by Trall
 - June 15, 2020, 10:07:29 AM

https://www.vulcandrifterriders.com/mods/Caddielights/writeup75.pdf

Yes I'm going to give it a go and try Greenbarn's write up to install.

This past year I was working 20 Hours overtime each week and this year I've done only  20 hours for the whole year so I got more time on my Hands the try.

It's been on my bucket list of mods to do for my Drifter.

Thx, Wish me luck.

Posted by chief
 - June 13, 2020, 19:20:06 PM

I assume you read this... there are several ways to do it and some are pretty easy.

https://www.vulcandrifterriders.com/caddytaillight.html

Posted by Trall
 - June 12, 2020, 06:20:20 AM

Their some awesome Awesome Drifters on this site with Cadillac Lenses.

Any Fabricators or Machinist doing the mod. and making the required adapters to install them?

Beyond my skill level.....If so PM me and I would happily pay you to make me a set of adapters for my Drifter 1500. 

SMF spam blocked by CleanTalk