Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by drifter-paul
 - October 05, 2018, 05:34:27 AM

Moto,

Use your thumbnails or a wooden paddle pop stick to ease the semi-hemisphere plastic cap off the housing stalk, and along the wire towards the brake light / licence plate housing. You will then see the 14mm nut. It is rubber mounted. The plastic cap is a clip back on fit.

:)

Posted by moto
 - October 05, 2018, 04:50:01 AM

Hi

where I can tighten my Drifter rear turn signal, it is now little slacky. I cannot find any bolt.
Is bolt inside turn signal rod?

SMF spam blocked by CleanTalk