Tighten rear turn signal

Started by moto, October 05, 2018, 04:50:01 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions

moto

#3
October 05, 2018, 06:43:59 AM
Quote from: drifter-paul on October 05, 2018, 05:34:27 AM

Moto,

Use your thumbnails or a wooden paddle pop stick to ease the semi-hemisphere plastic cap off the housing stalk, and along the wire towards the brake light / licence plate housing. You will then see the 14mm nut. It is rubber mounted. The plastic cap is a clip back on fit.

:)

Yes, I knew it! Thanks Paul!
Let the good times roll

drifter-paul

#2
October 05, 2018, 05:34:27 AM Last Edit: October 05, 2018, 05:39:12 AM by drifter-paul

Moto,

Use your thumbnails or a wooden paddle pop stick to ease the semi-hemisphere plastic cap off the housing stalk, and along the wire towards the brake light / licence plate housing. You will then see the 14mm nut. It is rubber mounted. The plastic cap is a clip back on fit.

:)

Knowledge is knowing a tomato is a fruit, wisdom is not putting it in a fruit salad.

moto

#1
October 05, 2018, 04:50:01 AM

Hi

where I can tighten my Drifter rear turn signal, it is now little slacky. I cannot find any bolt.
Is bolt inside turn signal rod?

Let the good times roll
Print
Go Up Pages1
User actions
SMF spam blocked by CleanTalk