GUEST? Registration opens up many more resources which are not available to guests. Registration is free, we never sell or give others access to your information.
Posted by RockinRollin
- March 21, 2018, 06:53:13 AMThis is the 3" risers? Anyone try this on a 1500? Same results?
Posted by CDNRatMan
- March 20, 2018, 21:30:59 PMSorry Lord OR_Seedman for ever doubting your wisdom......beg forgiveness......
GB I guess I could if I had a lathe then turn the cap down a bit then re drill the holes that hold it in place, because it is really close, so I'll go lathe shopping in the morning.....not sure if any of the stores around here carry desk top lathes.....
Posted by greenbarn
- March 20, 2018, 20:16:56 PMSo just mount them opposite, pointing forward, and they shouldn't hit the speedo housing - I don't see a problem here.... LOL.
Looking at the picture, the knob on the end looks really big-- how much is it hitting the housing?? could put that cap in the lathe, and turn about 1/2" off the end, would that do the trick??
Posted by OR Seedman
- March 20, 2018, 19:59:33 PMNever doubt me again! LOL
Posted by CDNRatMan
- March 20, 2018, 16:00:24 PMOR_Seedman: once again you have proven correct, I mounted these last night on Pearl (Raven) and they looked like they just might fit, and it was a very close fit, but once you get everything in place yup it dos tap the dash housing enough to make it not a good thing. So for the rest of the build and till I find what I am after I will use the stock risers, and you know with the handlebars I have picked I just might not need the high risers.
Welder dropped by with my tacked seat frame and we get the final adjustments made, he is going to finish welding iit tonight and we came up with a very novel idea for the frame so it shall be done....lol.....