Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by Troll
 - March 30, 2017, 13:06:04 PM

There are two identical sensors under the tank. One is Baro, and the other is MAP. Baro sensor has it's vacuum hose fitting open to the air (to measure BAROmetric pressure) and MAP has it's fitting connected to the manifold to measure vacuum (manifold absolute pressure). The sensors are the same part number, so the wiring color code will tell you which one is which...

Posted by Trall
 - March 29, 2017, 03:02:33 AM

Idk.  You might check Partzilla.   You can pull up the parts you're looking on their diagram will show all the related parts and there placement on the bike for that area. 

Posted by rimshot
 - March 28, 2017, 21:48:25 PM

hi when i had a hypercharger installed all the lines and hoses were pulled off and never replaced. the only thing im trying to work out is the hoses from the pressure sensor / air water switch relay sensor ? where should it connect to? thanks

SMF spam blocked by CleanTalk