Post reply

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by drifter-paul
 - July 09, 2024, 00:51:45 AM

Checking my ECU codes (Thanks Chief for the PDF)

1 Kill switch on
2 Turn on ignition switch
3 The FI light should turn on for 1-2 seconds, then turn off

However what confuses me is - when I ground terminal #37, no error code blinks .

I turned the Rider Down sensor upside down and grounded again , expected Fault #31 - but no blinks .

I put the Ohm meter on my ground wire , it is fine .

I used bottom left of the 8 pin block , with the longer pin blocks to the right, as per PDF

Anyone experienced this ?

Just to make it interesting - it is starting again, Wed yes Thu/Fri no, Sat/Sun yes,  Mon untried, Tue/Wed yes

SMF spam blocked by CleanTalk