Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Isch

#1
Drifter 1500 only / Re: no spark....please help
August 19, 2019, 20:25:46 PM

With that info, when is the last time you changed the spark plugs? I have also found that the plugs need to be changed or cleaned on a regular basis, especially when moisture is present. For some reason, maybe low system voltage, the spark plugs need to be really clean. I keep a spare set in my saddle bags for this reason. Have you checked the coils?  I know how frustrating this is, I've been down that road. Being a plumber, by trade, I often get frustrated by electrical problems.
The solenoid is mounted near the fuse block. Pull the right side cover, and look, I believe, on the top left side of the fuse block. The solenoid, "relay", according to the manual, is mounted with a rubber shroud, slipped on to a little metal tab. Don't have any pics, and have trouble figuring out how to upload them. I will try this weekend, to get a pic and post it. Just out of curiosity, how many miles on your scooter?

#2
Drifter 1500 only / Re: Old new guy
August 13, 2019, 18:30:27 PM

Will do that tomorrow....  ;)
Ack! More likely, this weekend.....After work  :)

#3
Drifter 1500 only / Re: Old new guy
August 12, 2019, 20:47:12 PM

From what I can tell, the engine is fine. It starts and runs great. I can sit in my driveway and rev the engine and look real cool......I just can't go anywhere. The other day, I was going to try to ride to our monthly meeting, about 40 miles away, but just riding to the gas station about three miles down the road, to fill up, convinced me that I would probably not make it back home, so I had to cage it to an MC meeting.  >:( >:( >:(
One reason I was looking to find another motor, was that while servicing my clutch, I came across a procedure in the service manual for checking the "free play" in the clutch spring, that required the use of a "spare" primary drive shaft. That's the one that basically runs from one side of the transmission to the other.
I eventually plan to split the case and repair this thing, but, since I plan on keeping it until I die, I figured I could use some spare parts. Considering how rare these birds are, I got my work cut out for me.

As for as noises and their location, the main way I can describe it is there is a "rattling" sound that is most pronounced in 4th and 5th gears, when I am either on the throttle or, even worse, when I'm kind of just maintaining. When I let off completely to decelerate, the noise and some of the vibration go away.

Last time I took it to the local factory authorized shop, it cost me almost $400 for them to trouble shoot it, do a little rewiring, and ultimately, not even find the real problem. (You can read a reply to Balthazar from earlier today to get some background on that)
I'm getting closer to the conclusion that I will actually have to go that route though.
Thanks for the input, and I'll keep you guys posted.

#4
Drifter 1500 only / Re: no spark....please help
August 12, 2019, 19:55:42 PM

Balthazar,
I had this same problem with my own '99 1500 shortly after I first got it. I chased a whole bunch of ghosts for about 3 years. It mainly manifested when I would try to start it, and I looked at everything having to do with the ECU power and the DFI. The problem ultimately turned out to be the first thing I looked at. There is a solenoid that closes the circuit for all the stuff that makes the engine actually run. I tested it and found that I had continuity, and dismissed it. The first time I and a brother from the club were on our way to Pigeon Forge and it actually quit while we were cruising down the interstate, I really got concerned.
I eventually decided to go ahead and buy the solenoid (I think it was about $50). After replacing it, I have not had that problem again.
Check to see if all the instrument lights, the oil pressure test, the low fuel light, the temp. warning light come on for the initial self-test and you can here the fuel pump come up to pressure when you first turn on the ignition. If all that doesn't happen, get the new solenoid.
When I tested it initially, I didn't cycle it enough. The problem was kind of random because, while the coil in the solenoid would pull in, it would not always actually make contact. Frustrated the heck out of me for a long time. Hope that helps.

Isch,
SoGMC

#5
Drifter 1500 only / Re: Old new guy
August 08, 2019, 19:19:05 PM

I haven't specifically checked the final drive aspect. The vibration characteristics tend to increase in severity more in relation to which gear it's in than with the actual speed of the bike. It's definitely worse at higher speeds, but I can shift into a different gear at the same speed and get it to sound different. That's what makes me think it's transmission related.
I will check out the driveshaft though, because there may be something to your suggestion. I considered it myself and dismissed it because I had just checked it last season, and everything in there looked fine. Changed the oil, and called it good. I'll post back on the results.

#6
Drifter 1500 only / Old new guy
August 07, 2019, 17:55:51 PM

Hey guys. Just wanted to say hey. I joined this site back when I first acquired my scooter. Have moved twice and something like six years have passed since then, but I have enjoyed the heck out of her since then. Don't know what happened to my old log in, but I just registered again.
Not being a tech savvy sort, I hope to figure out how to upload a picture or two, but at the moment I have another challenge. I need to find a motor for my '99 1500 Drifter.
Earlier this year I rode to Ohio for the semiannual national meeting for the club I ride with (Shameless plug: Sons of God MC, Manassas VA) and about 75 miles outside of Dayton, I started noticing a serious vibration, then a rattling noise coming from the transmission. It was most predominant in 4th and 5th gears. I didn't want to chance trying to ride home to VA, so I rented a trailer and got one of the brothers to hook it to the back of the cage they came up in.
Due to a number of circumstances, I have yet to be able to either crack it open, or come up with the funds to have someone else dig in and fix the problem. For one thing, I haven't yet found a mechanic that I feel confident about to fix the thing, at any price. Talking to them, I get the sense that they don't know much more than I do about these bikes. I have a pretty good sense about mechanical things, in general, and I'm confident that I could dig in and fix it myself, if I had the time.
Right now, I'm looking for a motor, so that I can get back on the road (I'm sick of not being able to ride, and this season is almost over). Also, with a spare motor, I can take my time and do the rebuild right. Engine is strong, with only 75k miles, and this bike has been such a joy to me, that I want to keep riding it forever. I'll never sell it and I want to find a way to keep it functional within my means.
Anyone got any suggestions or leads on a motor that will fit?

SMF spam blocked by CleanTalk