Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Thiessen90

#1
Drifter 800 Only / Re: Drifter 800 floorboards
March 04, 2019, 00:11:13 AM

Okay sounds good I will start with trying to straighten the one I currently have, and if not maybe I will have to keep an eye out for a used one or break down and buy a new one.

#2
Drifter 800 Only / Re: Drifter 800 floorboards
March 02, 2019, 20:12:49 PM

I did try twice asking for more photos Old Drifter, sadly the seller has not responded to me.  I was also suspicious of the fact that it only had the one shifter and was not sure what that was about.

#3
Drifter 800 Only / Re: Weird issue this winter
March 01, 2019, 15:19:50 PM

I had a similar issue in a different bike, but that one was 2 carbs.  However it was a bad coil and it would run on one cylinder until you really pushed it and then suddenly the other cylinder would jump to life.  Turned out to be a bad coil.

#4
Drifter 800 Only / Re: Drifter 800 floorboards
March 01, 2019, 15:17:07 PM

So it is both the mount as well as the floorboard that is bent.  I have found one on ebay and just wanted to confirm with people if that looks to be the right one?  There are no pictures of the backside unfortunately but when I looked up the part online the top of the mount seems to match what I can see in this one.

https://www.ebay.com/itm/2000-Kawasaki-VN-800-Vulcan-Left-Drivers-Floor-Board/162569789569

#5
Drifter 800 Only / Re: Drifter 800 floorboards
February 27, 2019, 19:34:37 PM

Also the mount is different so I will have to check if that is bent

#6
Drifter 800 Only / Re: Drifter 800 floorboards
February 27, 2019, 19:21:41 PM

Thanks everyone I wasn't get a lot of results when I searched for the 800 so I thought I better ask before buying.

#7
Drifter 800 Only / Drifter 800 floorboards
February 26, 2019, 20:20:51 PM

My left side floorboards is badly bent from the previous owner dropping the bike in his garage, just wondering if a floorboard of a classic would fit?  Or if anyone knows of a used one kicking around?  Thanks

SMF spam blocked by CleanTalk