Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - lefecious

#1

Good news. Another drifter lover from this forum purchased the bike and plans to get it running and back on the road!

#2

The ad's up in the classified section if anyone's interested. Less than 4k miles and not currently running due to sitting too long.

Wanted to give folks on this forum a week or so before I listed it on Craigslist.

https://www.vulcandrifterriders.com/forum/index.php?action=classifieds;sa=view;id=422

#3
Quote from: chief on May 18, 2023, 12:44:36 PM

Are you getting any efi error codes?

Looks like I need to do some research. I don't even know how to check for efi codes. Thanks for the direction though! At least now I have something to check.

#4
Quote from: gwilki on May 18, 2023, 06:42:57 AM

Do you have spark?

I think I must have spark because when he sprayed the starter fluid it did "run" for like half a second.

If I didn't have spark, it would just crank and not ignite at all, correct?

#5

Hi all, drifter 1500 sat for years and I'm trying to resurrect it

So far I've cleaned out the fuel tank with vinegar, tested and cleaned the injectors, and replaced the fuel pump and battery.

Tried you start it but it cranks but won't catch idle.

I had a buddy spray some starter fluid into the air intake and it sounded like it was going to start. But only for half a second.

What else can I try?

#6

What's the part?

I've had to buy from 3 different places in the past year because often there's only one or two companies that will have the part you're looking for.

I went to quantum fuel systems for my fuel pump, partzilla for my fuel tank gasket, and parts giant for my master cylinder rebuild kit.

#7

Ok next time I have it open I'll clean out that little hole. I also confirmed that my line was clogged so thank you gilwiki for the advice there.

Partzilla and parts giant don't seem to carry it so I found this one. Anyone ever bought from them? I would imagine any hydraulic line will do if the length is right.

https://www.sportbiketrackgear.com/spiegler-kawasaki-vn-1500-vulcan-86-00-clutch-line-kit-orig/?sku=S%7CSP%20S-KA0271-BLK-BLK%7C0&gclid=CjwKCAjwitShBhA6EiwAq3RqAyp13IOOKLK0j_DTFB7xWzRhKVSe9GxllD_s4gVofRa9wzhDJY6kdBoCes4QAvD_BwE
#8
Quote from: Tim on April 06, 2023, 12:23:46 PM

There is a tiny orifice in the reservoir - if you have a wire brush cut off one bristle, hold it with needle nose pliers and ream the hole. That fixed my problem

Do you mean that little air hole in the side of the reservoir? Or something else?

#9

Bike had been sitting for years and the clutch lever had no resistance. I thought it was the master cylinder, so I bought a kit and rebuilt it and now I'm trying to refill the lines with brake fluid and bleed it, but it doesn't seem to work.

I attached a piece of clear tubing to the bleeder valve, filled up the reservoir, then I pull the clutch lever in, hold it, then open the bleeder valve for a second, close it again, and release the brake lever. I repeated those steps dozens of times and sometimes a bubble came out, sometimes nothing. But no fluid really ever progressed into the tubing.

My buddy was there and he's bled brakes on a car many times and he was convinced something else it broken because it should have built up pressure by then.

Is there a secret to this?  Do I need to by one of those bleeder vacuum pump things?

#10
Drifter 1500 only / Re: Replacing fuel pump questions
February 27, 2023, 23:09:24 PM
Quote from: Troll on February 08, 2023, 15:43:58 PM

The little cylinder mounted on the bracket, is the low fuel light sensor. On mine (2001) it's a little different and has a blue wire connected to it.

Thank you!  With a little research I discovered it's called a thermistor.  But it's not easy to find a replacement.  I've found some for hondas but I read that hondas use 10kohm and kawasaki needs 1kohm.  I don't even know what that means but it sounded like they're not interchangeable.

Also, I should've replaced the gasket.  It was borderline, and I put the whole thing together and put gas in it and sure enough, it leaked.  So I ordered the gasket and now I have to take everything apart again.

#11
Drifter 1500 only / Re: Replacing fuel pump questions
February 06, 2023, 20:50:46 PM

Thanks for the responses.  I'll look for the grommet.  I found one for 48 bucks, which seems kind of steep for a piece of rubber, but that's the price you pay when you ride a 20+ year old obscure bike I guess.

Quantum Fuel Systems has one for less but the picture is completely wrong. I know the part often looks different from the one in the photos but my trust in Quantum has gone down after today.  The replacement fuel pump I bought from them had the wrong strainer.  it's exactly the same issue that a user here experienced years ago:
https://www.vulcandrifterriders.com/forum/index.php/topic,43450.msg97256.html#msg97256

If you read the final post in that thread by thenamos, he says he emailed them about the issue and they sent him the right strainer, along with a new pump to keep as a spare.  I ordered from them because of that post.  And when the same thing happened to me I emailed them about it and today I got a response via email that says "Unfortunately, we do not stock that OEM strainer."

If they don't have that strainer then maybe they shouldn't list it as compatible with the 1999 drifter.

Now I have to decide if it's worth my time to fight over a partial refund.  Probably not.

I do have the shop manual though.  It doesn't explain what the little cylinder is.  I'm guessing maybe something to do with the fuel guage, because I didn't see any kind of float assembly in there so I'm not sure how it knows how much gas is in the tank

#12
Drifter 1500 only / Replacing fuel pump questions
February 05, 2023, 21:48:59 PM

Trying to resurrect my drifter that sat for years. Removed the tank and cleaned out the rust. Learned from this forum that quantum fuel systems sells a replacement fuel pump for around 90 bucks so I thought I may as well replace that too while I have the tank off.

My first question is what is that little cylinder all the way on the right side of this photo?  The one with the wire coming out of it?  It seems delicate, and the wire moves loosely inside there.  Just wondering what this thing is and if that's supposed to move like that?

Second question is do I really have to replace that rubber grommet at the bottom of the pic?  If so, where can I get one?

Also, is there a page that tells you how to do this replacement job?  I found an old post on here that had a link to such a page but the link is no longer valid.

#13

Sad day for me, brothers.  I think it's time to let the drifter go.

I fell in love with drifters around 2004 I think and bought a used one with hardly any miles. Gave it a custom paint job, indian badge and fender light, tan solo seat with the matching tan two-up seat for when I needed to take a passenger.  Found this forum and really appreciated the helpful tips and advice.  Hoping you have one more piece of guidance for me.

I had multiple close calls due to bad drivers in my town.  Any one of them could've been fatal.  I thought long and hard about how many people depend on me, and ended up deciding that I'd never ride on the streets again, and I got a dirt bike instead so at least I won't be killed by some idiot texting while driving. I had made up my mind to sell my drifter, but I just never got around to it.  I don't know if it was simple procrastination or if I subconsciously didn't want to let it go.  But the result is that it wound up sitting in my garage for years, with gas in it (I know, I know, I screwed up).

Anyhoo, now I find myself hurting for cash so I have to let it go.  It ran great when I parked it, which I think was 6 or 7 years ago, but obviously it won't start anymore, and would need a battery and fuel system cleaning to get it going.

My problem is that I haven't really been in touch with the drifter community, or any motorcycle community in years.  I don't know if these are in demand these days or not.  So I'm having trouble figuring out how much to list it for.

1999 CA model 1500 with 3870 miles.  Never been dropped.  What's a good starting point?  I'm about an hour north of Los Angeles.

Any advice?

#14

Hi all. I've never done this before so would appreciate some guidance. I'm also not an experienced mechanic so explanations as if I were a 4 year old would be appreciated.

So far I've replaced just the battery.

I know I need to change the oil and clean out the fuel system somehow.

First question is should I change the oil first, even though I can't start the bike and warm it up? I'm guessing the answer is yes, as a cold oil change would probably be better than running the bike on old oil. But please correct me if I'm wrong.

2nd question is where to start with the fuel system?  Can I drain the tank without removing it?  Is siphoning out the gas good enough? And just replacing with fresh gas?

When I shine a light down there the tank doesn't look all that dirty. Although the gas cap had a bunch of crud built up in the inside of it.

The fuel gauge also said empty even though there's gas inside so I'm guessing there's a float valve that's stuck. So maybe there's more crud than I can see in there.

#15

Had it been sitting for a while?

Does the key turn all the way or does it get stuck?

I had the same problem after my bike sat unused for a couple years. The latch was stuck because of all the corrosion and buildup of gunk.

Here's what I did.

I sprayed some graphite lube into the key hole, then
I pushed down on the cap to relieve the pressure on the latch. Then while holding it down like that, I just stick the key in and wiggle it and turn it as far as it would go about a million times. It's tricky because I wanted to turn hard but also not so hard that it breaks the key. Eventually, the key turned all the way and I got it open.

There was so much crud on the other side of the gas cap, I still haven't gotten it all off. This was just last night.

SMF spam blocked by CleanTalk