Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - hawkfan

#1
Drifter 1500 only / Re: After Market Fuel Gauge?
November 20, 2020, 16:50:07 PM

with the gauge out of the tank, the ohms read 27 ohms when empty and 104 ohms when full.  Seems like the sending unit is bad?

Thanks

#2
Drifter 1500 only / Re: After Market Fuel Gauge?
November 18, 2020, 16:53:27 PM

Thanks Troll.  I'll check it out this weekend.

#3
Drifter 1500 only / Re: After Market Fuel Gauge?
November 17, 2020, 17:46:39 PM

After I took apart the speedo instrument apart I moved the fuel gauge needle to empty. I hooked the instrument back up to the bike and powered it up.  With the tank totally empty, the fuel gauge needle gradually creeped back up to full.  Not too sure what to make of this but I'm guessing the actual fuel gauge receiver with the needle is shot.

#4
Drifter 1500 only / Re: After Market Fuel Gauge?
November 16, 2020, 17:28:49 PM

Thanks Troll !

#5
Drifter 1500 only / After Market Fuel Gauge?
November 15, 2020, 13:46:32 PM

Has anyone had experience installing an after market fuel gauge?  Seeing how I am not having any luck finding a direct replacement speedometer/fuel gauge the next best step is to look into installing an after market.

Thanks

#6
Drifter 1500 only / Re: 01 Drifter 1500 Fuel Gauge Issue
November 14, 2020, 18:50:06 PM

Thanks Troll !!!!

#7
Drifter 1500 only / Re: 01 Drifter 1500 Fuel Gauge Issue
November 14, 2020, 15:28:43 PM

I was able to disassemble the the speedometer gauge package.  The needle of the fuel gauge seems to have some resistance when i gently move it with my finger.  Not sure if thats normal.  I would think it would move more freely.
I looked up the price of a replacement instrument head and Yikes!!!  Is there a source where I can just purchase the fuel pod?

Thanks
Brian
Tinley Park, ILL,

#8
Drifter 1500 only / 01 Drifter 1500 Fuel Gauge Issue
November 14, 2020, 14:38:19 PM

My fuel gauge is stuck on full even though I emptied the tank for the winter.  Its been like this most of the summer so I just monitor my mileage.  I disconnected and removed the speedometer head and its still pegged to full.  Would anyone have any suggestions?  I looked it up in the manual on how to test the gauge but I dont have a rheostat.
Also.  Is there anyway to adjust the low fuel light as my low fuel light comes on and I still have 2-1/2 gallons of gas left.

Thanks

#9
Drifter 1500 only / Bullet Style Tail Light Lenses
October 20, 2019, 07:17:33 AM

Does anyone know if some company makes bullet style tail light lenses that are simular looking to the ones on a 59 Caddy?  I see they make simular fixtures but they all are flush mounted.  Im looking for something that I can unscrew the original lenses and fasten the new ones in place.

Thanks
Hawkfan

#10

Thanks for the response!!!

#11
Drifter 1500 only / Re: No Electric to rear of bike
September 02, 2018, 17:10:30 PM

Got it figured out.  Some how 3 of the wires headed to the back of the bike got severed in half right before the socket where the main harness connects to the rear harness.  Something must of popped up and hit the wire bundle just right.

#12
Drifter 1500 only / No Electric to rear of bike
September 01, 2018, 21:23:30 PM

Was gonna take a ride this evening when backing the bike out of the barn I noticed I have no lights at all in the rear of the bike.  I have lights and turn signals up front. I checked the fuses and the all check good.  I had a spare rear harness which I replaced with no improvement.  Is there any other fuses or circuits I may be missing?  Im not real good when it comes to trouble shooting electric so I would appreciate any assistance near me.  Also.  Would anyone have any suggestions for a good motorcycle mechanic in the Tinley Park ILL area?

Thanks
Hawkfan
Tinley Park, ILL.

#13

I know the shock distance is measured from center line to center line but are they measured in the free state or in the installed state?  my center line measurement is 12.750 so do i get the 12.5" or 13"?

Thanks

#14

Would anyone know the life expectancy of the original factory shocks would be?  I have a 2001 with 25,000 miles and am wondering how long they should last.  With the price of replacement OEM shocks at about a grand, what would be a good quality replacement shock that someone could reccomend?

Thanks

#15
Drifter 1500 only / Re: Quality Tire?
June 03, 2017, 09:49:26 AM

Thanks for the responses!

#16
Drifter 1500 only / Re: Quality Tire?
June 02, 2017, 20:22:54 PM

I'm actually considering those!

Thanks

#17
Drifter 1500 only / Quality Tire?
June 02, 2017, 18:16:57 PM

I'm getting to the point where I'm going to replace my tires and am looking for some input or suggestions on what are the good tires out there.  I currently have Shinko white all tires on my 1500.  I installed them about 2 years ago and they are close to being worn out after only 13,000 miles.  I feel they wore out rather quickly.  I checked tire PSI every two weeks 29 F 36 R. Is that what is expected from motorcycle tire life?
Anyway, I want to stay with the white wall.  Any suggestions for a good tire to look into?

Thanks

#18
Drifter 1500 only / Re: Cowls, Fairings
September 22, 2014, 17:14:02 PM

Thanks to all for the prompt & great responses!

#19
Drifter 1500 only / Cowls, Fairings
September 21, 2014, 21:05:43 PM

Has anyone come accross any cowls, fairings, wind deflectors that would fit the Drifter?  With fall upon us, it caused me to look into.

#20
Drifter 1500 only / Re: Pin Stripe Stencil
July 16, 2014, 19:34:09 PM

Nicely done!  Looks sharp!

#21
Drifter 1500 only / Re: Pin Stripe Stencil
July 16, 2014, 17:04:15 PM

Thanks for everyone's input!!!

#22
Drifter 1500 only / Pin Stripe Stencil
July 16, 2014, 06:15:02 AM

Does anyone know if there is a pin stipe stencil or kit out there for the Drifter fenders?  I'm looking for the large arches on the sides of the fender.
Thanks in advance.

#23
General Discussion / Re: Fender Material?
July 15, 2014, 16:05:17 PM

Gentlemen,
Thank you both.  It looked like some sort of plastic but I didnt think they would make fenders out of a form of poly.  I didnt even think of the bumper repair material.  I'll pick some up tonight.  Again, Thanks!

#24
General Discussion / Fender Material?
July 14, 2014, 16:34:15 PM

Would anyone know what material the fenders are made of on a 1500 Drifter?  I made the saddle bag mods to carry two hard case bags off the seat frame.  I made a 1,242 mile trip around Lake Michigan over the weekend and some of the roads in the U.P. werent the best.  I hit a good size pot hole which drove the fender up into the bottom side of the seat frame and the bracket bolts were a little longer then they should have been.  Yep.  Two nice souvinors.  I'd like to get the correct repair compound to make the repairs.
Thanks in advance for any assistance anyone can add.

SMF spam blocked by CleanTalk