Checking my ECU codes (Thanks Chief for the PDF)
1 Kill switch on
2 Turn on ignition switch
3 The FI light should turn on for 1-2 seconds, then turn off
However what confuses me is - when I ground terminal #37, no error code blinks .
I turned the Rider Down sensor upside down and grounded again , expected Fault #31 - but no blinks .
I put the Ohm meter on my ground wire , it is fine .
I used bottom left of the 8 pin block , with the longer pin blocks to the right, as per PDF
Anyone experienced this ?
Just to make it interesting - it is starting again, Wed yes Thu/Fri no, Sat/Sun yes, Mon untried, Tue/Wed yes