Taking the prop-stand off to grease the pivot is a pain because of the strength of the spring, as I found the first time I tried it. As a consequence I think that few people bother, leading to wear in the frame lug. This is a Bad Thing (Apologies to Messrs. Sellar and Yateman).
As a quick fix I modified my existing pivot bolt by adding a grease nipple (a Zerk to you US chaps) to the head of the pivot-bolt. That worked OK, but the bolt had distinct wear marks so I ordered a replacement.
The new mod has the grease-nipple fitted to the underside where it is not noticeable. The grease gets pumped into a shallow groove so that it is distributed all around the bolt. When I fit the new one I'll shim the pivot as well and that will also help to reduce wear.
The prop stand will now get a lube everytime I do the rear suspension.
Ok Pete as you pointed out to the US chaps that a grease nipple to us is a common word and for them Yanks it is a Zerk fitting. But you might want to tell them that a prop-stand is the side stand, they might be looking for something else all day and not find it....... 8) ::) lol......
Quote from: CDNRatMan on September 13, 2017, 11:02:39 AM
Ok Pete as you pointed out to the US chaps that a grease nipple to us is a common word and for them Yanks it is a Zerk fitting. But you might want to tell them that a prop-stand is the side stand, they might be looking for something else all day and not find it....... 8) ::) lol......
I always knew where the prop-stand was on my motorbike. ☺
Have to admit, nipples are preferable to zerks any day..... 8)
That's a good mod, Pete.
Groovey idea!
If I might recommend..... You could used one of those 'button' grease fittings (as opposed to a nipple) so there's nothing sticking out to break off (of course, then you'd have to use a grease 'needle' so that could be a downside).
Quote from: Bucko on September 13, 2017, 22:39:49 PM
Groovey idea!
If I might recommend..... You could used one of those 'button' grease fittings (as opposed to a nipple) so there's nothing sticking out to break off (of course, then you'd have to use a grease 'needle' so that could be a downside).
Inventions of the Devil, sir, get thee behind me!
I can't imagine how I would break one, but even if I did I'd just extract the stub and fit a new one, or modify another bolt; the bolts are as cheap as chips.
knew what you were refering to, I always called it a kickstand. Good idea.
Quote from: Pete on September 14, 2017, 05:55:27 AM
Inventions of the Devil, sir, get thee behind me!
I can't imagine how I would break one, but even if I did I'd just extract the stub and fit a new one, or modify another bolt; the bolts are as cheap as chips.
Sorry, I was thinking about the fitting being on the front/head of the bolt.
Quote from: Bucko on September 15, 2017, 00:46:09 AM
Sorry, I was thinking about the fitting being on the front/head of the bolt.
The original, temporary, version did have the nipple on the top.
This morning I fitted the one pictured above with the nipple of the thread end. I also made a shaped 0,55mm shim to take out the play in order to further reduce wear. It works great.