So a couple of winters ago I came up with this idea and went and bought 3 wrenches. 22 mm, 12 mm, and a 14 mm. Then modified them to be my chain tools, I ground the box ends to be a tad thinner than the lock bolts on the chain adjusters, and the chain adjustment nut. I then took the 22 mm and heated it up with my propane torch and bent it so it would not cause me to whack my knuckles and let me loosen the axle nut and not jam my hand. Take very little space and are easy to pack.
also a challenge to most of you out here, over the winter as you work on a project, try using just your tools that come in the tool kit. The year I did my valve check I did just that and used nothing but the tools from the tool kit other then I had the bike on a jack and not the side stand. That was the logic and reason for the chain wrenches. Not all of us have a trailer to haul out tool boxes with all our fancy torque wrenches and sockets around with us on a tour. During a rainstorm or in the dark when you are broken down is not the time to try and figure out how to use your tools in the bike or where are they......
Not bad cousin Ratman, I just wish I had the standard tool kit that should have came with the bike.
Great idea!
Yeah, cool idea!
Good old Canadian ingenuity in action! I like it!!!
He has lots of time on his hands, since he's snowed in.
Thanks guys and Troll not snowed in quiet yet.
Lots more ideas to tinker with, more ideas to flesh out and a Drifter event to work on so lots to keep me busy......
Nice idea. And the little green squirrely thingys make nice wrench holders.
That would make a nice addition to a tool kit.
8) and do you need more of the green squirrely things? Or would you like them in purple, orange?
Quote from: CDNRatMan on December 02, 2016, 21:57:35 PM
8) and do you need more of the green squirrely things? Or would you like them in purple, orange?
OOH, orange would match the bike... :D I'm probably doing OK, though.
Tomorrow I am travelling to Walden to watch Logan play in a hockey tournament, but I am going to go Sunday and buy a bunch of orange ones in different lengths for you..........
Quote from: CDNRatMan on November 30, 2016, 21:38:19 PM
So a couple of winters ago I came up with this idea and went and bought 3 wrenches. 22 mm, 12 mm, and a 14 mm. Then modified them to be my chain tools, I ground the box ends to be a tad thinner than the lock bolts on the chain adjusters, and the chain adjustment nut. I then took the 22 mm and heated it up with my propane torch and bent it so it would not cause me to whack my knuckles and let me loosen the axle nut and not jam my hand. Take very little space and are easy to pack.
also a challenge to most of you out here, over the winter as you work on a project, try using just your tools that come in the tool kit. The year I did my valve check I did just that and used nothing but the tools from the tool kit other then I had the bike on a jack and not the side stand. That was the logic and reason for the chain wrenches. Not all of us have a trailer to haul out tool boxes with all our fancy torque wrenches and sockets around with us on a tour. During a rainstorm or in the dark when you are broken down is not the time to try and figure out how to use your tools in the bike or where are they......
Darn, now you voided the warranty on those nice wrenches!
;)
lol nope no such thing.......I just go back the Home Hardware with the broken tool and get one off the shelf and then they fill out their paper work and I come home with a new tool..........