Post reply

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by ChilliDrift
 - April 06, 2013, 17:18:56 PM

Bearing puller.    :o

Posted by pcarrell
 - April 06, 2013, 16:43:16 PM

gorilla tape

Posted by ChilliDrift
 - April 06, 2013, 16:39:24 PM

Dental pick.

Posted by Petemoss
 - April 05, 2013, 22:51:36 PM

My fingernail. Usually my thumb.  :D

Posted by CDNRatMan
 - April 05, 2013, 21:16:59 PM

yup if your talking about the caps covering the allen heads, then a small really fine flat tip screwdriver......

Posted by greenbarn
 - April 05, 2013, 20:47:11 PM

I'm not sure what end caps you're referring to??  My 800 has stainless caps on almost every allen-head bolt on the bike, from the PO.  I use a real small screwdriver to pry them off.  It also has chrome covers on the front axle- both ends.  They are held in place with a very small allen-head set screw accessed from underneath.  Hope that helps.  If not describe  yours or post a pic.

Posted by plevine1
 - April 05, 2013, 20:19:08 PM

What tool or trick do you use to remove the round end caps all over the bike?

SMF spam blocked by CleanTalk