Post reply

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by CousinVinny
 - April 16, 2012, 20:23:58 PM

Thanks for all the info, the synthetic engine oil  is a great idea, I hear that rap -rap too when its cold. I ordered a seal kit for both slave and master. I forgot that the slave is out in the open, funny I wasn't too crazy about how its mounted there when I got the bike, but now I'm sure glad its not buried. Fresh fluid and I should be back on the road. I'll post how it goes. 

Posted by 49Reo
 - April 15, 2012, 21:14:02 PM

My '02 would (in the spring, after sitting all winter) not disengage unless I held the clutch in for up to maybe 2 minutes; once I rode a bit, it was always good. i switched to Kawasaki synthetic oil, never had that problem since. I realize this is not your situation, but food for thought...also, upon start-up, the little man with a hammer  hiding inside my engine ;D would go tap-tap-tap in the top end until it warmed up; not a peep since I switched to synthetic oil.

Regards and such,
49Reo

Posted by Troll
 - April 15, 2012, 20:29:27 PM

At least with a '99 you don't have to remove the chrome cover on the left side to get to the slave cylinder.

Posted by chief
 - April 15, 2012, 19:15:52 PM

That sort of failure isn't common... start simple and check the fluid... the master can be troublesome if the fluid and seals have never been changed.

Posted by CousinVinny
 - April 15, 2012, 16:56:31 PM

Hello everyone, I went out today to start my Drifter, she fired right up but the the clutch lever had zero resistance on it. Its not disengaging the clutch at all. This has the  hydraulic set-up and there is a master on the bars, and I assume the slave is down below at the tranny.  I believe one of the two is blown, is one more common to go than the other?
Thanks for reading,  -Vinny 

SMF spam blocked by CleanTalk