Post reply

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by Indy
 - October 22, 2011, 03:41:46 AM

Not in 5 min, just do it carefully..

Indy

Posted by KEN.
 - September 11, 2011, 04:37:25 AM

Hello All........I just had my rear fender off...only takes a few minutes....It'll be faster next time as I notch cut the bracket behind the muffler, so now i just
have to undo the bolt a little instead of removing it... Works for me....KEN.

Posted by TripWire
 - August 19, 2011, 20:45:15 PM

I would recommend shortening the bold by the exhaust once you get it out.  Mad my life a lot easier.

Posted by vf24renegade
 - August 19, 2011, 18:31:04 PM

5 minutes is a good estimate until you come to the long lower bolt that's difficult to get out because the exhaust is in the way. Then it takes considerably longer.

Posted by chief
 - June 15, 2011, 12:24:29 PM

Now we know!

Posted by jamman
 - June 15, 2011, 12:21:08 PM

The main wire from the fender goes into a box under the seat ... pull the connector out of the box and disconnect

Remove the six bolts on the fender and take off ..

Can be done in 5 mins without removing the seat .. 

Posted by chief
 - June 15, 2011, 11:59:13 AM

Don't know, but I suspect there are some... maybe in the light buckets themselves or under the seat??? Don't have an 800!

Posted by Indian Drifter
 - June 14, 2011, 22:52:29 PM

OK I'm removing the rear fender... Are there any electrical plugs to disconnect  in order to remove the lighting?? Or do I have to cut wires??

SMF spam blocked by CleanTalk