We limit access by GUESTS to protect our members from spam, hacks and trolls. Please register to gain access to all our resources.
Posted by greenbarn
- January 15, 2019, 21:21:01 PMGlad you got her fixed up.
Posted by paulfuller12
- January 12, 2019, 09:57:53 AMQuote from: greenbarn on November 17, 2018, 07:15:53 AMThe stock ignition and thunder switch both have a parking light position when switch turned to the left. its a separate circuit to the tail light only so as not to run down the battery so fast. I heard in some European countries you have to leave the light on when leaving the bike parked. According to the wiring diagram current takes a long trip thru the harness then to the light. It wasn't getting current and I couldn't find where. So I just crossed the "parking light wire with the switched hot at the ignition switch and yea, viola light.The wiring for all of the rear lights cluster into the tail light housing. I'd take off he cover there and see what you have and what you don't have. Do you have a 12V test light?
When you say you have a parking light, exactly what do you mean?
Posted by paulfuller12
- November 19, 2018, 15:47:04 PMThere was no power going to the tail light except when the thunder switch was in "park" position. I ended up connecting the red tail light wire to the blue switched power wire up at the Thunder switch harness. The OEM diagram shows when the OEM ignition switch is in the on position all wires are connected (hot). I spliced the red taillight wire to the blue wire so I would not interfere with the 100ohm resistor for the ignition. I disconnected the red spade connector from the switch terminal so now I don't have 'park" light but I would never use it anyway. Problem solved.
Posted by indue
- November 17, 2018, 13:04:31 PMPull the light lense off and check the bulb. It should be an 1157 (dual filament). Put in a new one if the two filaments look separated or if there is a dark/smoke color to the bulb indicating they have burned out. Otherwise, it is in the connection above the drive shaft left side.
Posted by greenbarn
- November 17, 2018, 07:15:53 AMThe wiring for all of the rear lights cluster into the tail light housing. I'd take off he cover there and see what you have and what you don't have. Do you have a 12V test light?
When you say you have a parking light, exactly what do you mean?
Posted by Troll
- November 17, 2018, 04:03:14 AMlicense plate light working? Brake light working?
Posted by paulfuller12
- November 16, 2018, 16:21:51 PMMy 2000 has small turnsignals with no running lights can that cause no power to the tail light? I was looking at wiring diagram and the running light are in a circuit to the tail light. I have got parking light. Has thunder switch and tail light fuse is good. Any ideas?