Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by Mak
 - August 19, 2016, 19:12:15 PM

agree and use plenty of wd40 while see-sawing it

but it looks a bit empty without them - and putting them back into exact position is a pain, a real pain.  Also - if you ever put them back on note that there is a slight difference in the curvature so there is a left and right side.

last comment: I think they look good in black ... ;D

Posted by Pilgrim
 - August 19, 2016, 18:46:44 PM

use fishing line and place it between the badge and tank and saw back and forth while pulling down..like your sawing the glue..may work better if you heat the badge with hair dryer first.
Then remove the adhesive residue with wd-40. clean and wax.

That's how I would do it.

Posted by Old Drifter
 - August 19, 2016, 17:55:09 PM

I'm thinking about removing the gas tank badges from my '99. Is it possible to remove them without damaging the paint? If so how? Thanks

SMF spam blocked by CleanTalk