Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by greenbarn
 - July 07, 2016, 19:34:12 PM

The backing plates for the '59 lights will fit just inside the diameter of the stock light bucket.  If you drill new holes in the '59 backing plates, they will  bolt right into the stock buckets with some appropriate sized screws.  Then the '59 lenses screw to the backing plates.   I used a bracket on each side, custom bent to fit, running from the bottom screw on the '59 lense, over to the bolt on the Drifter bumper cover (assuming you have a 2001 or later).  I made this from about 1/2 or 3/4 wide aluminum flat stock.  This stiffened up the lights a bit.

There are a few pics on this thread:
http://www.vulcandrifterriders.com/forum/index.php?topic=31695.msg69238#msg69238

Posted by Diddly squatt
 - July 07, 2016, 11:04:21 AM

I know a few of you have mounted the Caddy Bullet tail lights on your rear turn signal. I've read a couple of posts about making a bracket to help support the weight & keep horizontal.  How did you actually mount the new light fixture to the turn signal housing? Once again, thanks for your help. Mike

SMF spam blocked by CleanTalk