We limit access by GUESTS to protect our members from spam, hacks and trolls. Please register to gain access to all our resources.
Quote from: Tfrank59 on June 22, 2016, 17:09:08 PMI think it depends on what you mean by 'cool it better'. If the hole(s) diameter is larger than twice the thickness of the disk, there's a net loss of surface area for cooling. Not sure though, maybe having holes near the centre of the braking 'ring' of the disk - presumably where it's hottest - may remove heat quicker even with less surface area?Course the other reason for holes in a brake rotor is to cool it better.
Why not go for a 1500 Classic rotor instead?
I bought a VN 800 Classic rotor and put it on and it looks good and was not expensive, and married right on. Check for a used on ebay and as a machinist you will be able to ensure it is flat.
yep, I saw that. so with the front one what were they going for some retro look or something?
I'm considering putting some holes in the front rotor of my drifter whenever I get that wheel off to change the tire. I noticed that it has one deep score in it, I guess were a rock or something got caught in there, and that's going to happen when there aren't any holes in the rotor. Course the other reason for holes in a brake rotor is to cool it better. So I'm a machinist and I can put the holes in it, but I'm not a mechanic or engineer to know if that's going to adversely affect braking. I imagine the only issue would be if the brake pads aren't compatible with the rotor that has holes – can't imagine that being a problem but who knows. Any comments?
Page created in 0.058 seconds with 12 queries.