GUEST? Registration opens up many more resources which are not available to guests. Registration is free, we never sell or give others access to your information.
Posted by Downs
- April 23, 2016, 16:31:57 PMI ended up getting it off.
Used a paint scraper that fit the slot a lot more snug than the big driver I had. Then used vice grips and it opened right up.
So successfully changed the oil my first time. yay!
Here is another question, got back home from storage and I have a seat bolt missing, must have forgotten to tighten it. Are these chrome bolts hard to find? Can I just go get a couple at a hardware store or at the dealer?
Thanks team, appreciate the help.
Posted by aralph
- April 23, 2016, 16:12:01 PMLike Ratman says ,use a piece of flat stock that fits the whole slot. it needs to be the same width of the slot to apply pressure along the edge. Or try to find a drag link socket . Someone probably tightened it down dry with no oil on the rubber gasket. Same mistake people make with oil filters.
aralph
Posted by CDNRatMan
- April 23, 2016, 12:51:44 PMRelax, got a cold one, sit back and just rest your mind. Someone over tightened the thing, it does not need to be torqued in there like it is holding the whole bike together. I used a piece of flat stock and vise grips the one time I had an issue with it. I personally would not heat it up because it does have a rubber gasket on it. If you have a wide flat tip screwdriver then try using vise grips on the shaft to turn it but careful you do not want to strip it......
Posted by Downs
- April 23, 2016, 12:10:05 PMAbout to bring the bike out, down at my storage place.
Got old oil out, new filter on
cannot undo the screw to put njew oil in\
have a long screwdriver
not budging
help please