Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by CDNRatMan
 - April 23, 2016, 12:51:44 PM

  Relax, got a cold one, sit back and just rest your mind. Someone over tightened the thing, it does not need to be torqued in there like it is holding the whole bike together.  I used a piece of flat stock and vise grips the one time I had an issue with it. I personally would not heat it up because it does have a rubber gasket on it. If you have a wide flat tip screwdriver then try using vise grips on the shaft to turn it but careful you do not want to strip it......

Posted by Downs
 - April 23, 2016, 12:10:05 PM

About to bring the bike out, down at my storage place.
Got old oil out, new filter on
cannot undo the screw to put  njew oil in\
have a long screwdriver
not budging
help please

SMF spam blocked by CleanTalk