GUEST? Registration opens up many more resources which are not available to guests. Registration is free, we never sell or give others access to your information.
Posted by Pilgrim
- April 18, 2016, 12:24:22 PMget an ohm meter and check the wires to determine which one is open...sounds like the ground wire to me.
Check continuity from fuse block to pins.
Posted by Troll
- April 18, 2016, 08:51:38 AMThe wires don't change color. here's a map:
Posted by nhtrikes
- April 17, 2016, 18:48:02 PMHelp! Tail light, plate light, brake light are not working but the directional lights are. Checked the tail light/plate light fuse and it's good. Checked power to the fuse and that's good. Disconnected the rear fender harness connector and tested the prongs. Power to directional's good (lower two prongs), no power to the top 3 prongs, tail, plate and brake. Somewhere between the fuse box and the rear fender connector is a problem. Can't find the color coded wires from the rear fender connector anywhere else on the bike (fuse box or main harness inside headlight assembly). Any ideas where the wires for the tail light go from the fuse box and what color they would be before they get to the rear fender. The wires from the fender connector go into a large harness just behind the engine but not sure where they go from there. Everything else on the bike is working fine and she's running like a top. I'm so confused!