Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by CDNRatMan
 - December 06, 2015, 19:37:56 PM

    Well it would depend on your exhaust system. I have the roadhouse exhaust, and I just have to loosen off the rear mounts on the muffler, I can reach the lower fender bolt with no problem, and I can turn it out all the way and enough to work the fender out, but if I want the bolt out completely then I need to loosen the rear muffler mount a bit to be able to give the muffler a bit of movement.

Posted by Troll
 - December 06, 2015, 19:21:45 PM

According to the manual, you separate the muffler at it's joint and remove it....here's the page from the manual for you. I don't have an 800 but if this was mine, I think I'd look into using a stud and nut in place of the bolt.

Posted by Diddly squatt
 - December 06, 2015, 18:26:06 PM

Does the exhaust need to be removed to remove that blasted, lower rear fender bolt? Is it necessary to replace the exhaust gaskets every time the exhaust is removed? Thanks for your help.. Mike

SMF spam blocked by CleanTalk