Modify message

Welcome to Vulcan Drifter Riders. Please log in or sign up.

Main Menu

Vulcan Drifter Riders
► DISCUSSIONS
► Drifter 1500 only
► Modify message ( Re: Driving Lights )

Modify message

The message has the following error or errors that must be corrected before continuing:: Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.

Subject
Message icon
Reason for editing

Thanks for the input guys..............the Red/Blue wire that they used for power was cut.......so I've just got a wire screw on it for now.........I intended to just solder it back together or at least a butt connetcter with shrink wrap, and then just run my power to the relay from one of the front Aux power leads. Also, one of my power leads under the seat is dead.............now I'm unfamiliar with how Drifters work.......so should both leads have power and be able to handle a total of four bullet connectors? Just my wht/blu stripe wire is live right now
I imagine the wire they spliced was to the running lights as they come with the ignition.(red/Blu stripe)

Thanks again

Bob

Semper Fi

Attachments: (Clear attachments)

Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB

Uncheck the attachments you no longer want attached

Click or drag files here to attach them.

Insert width (px):

Insert height (px):

(Clear attachments)

Other options

Lock this topic
Return to this topic
Don't use smileys
Move this topic

Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by greenbarn

- May 24, 2015, 12:17:58 PM

Bikerbob, the diagram shows a 3-wire switch, like for a lighted switch. If yours just has 2 wires disregard the ground wire coming off the switch. There is a power wire and ground wire in the headlight bucket (double bayonet connectors) that you can use for the power and ground to the relay if you wish. For the "supply" wire to the switch, you could use the current wire you described that is powering the lights. That way it is only powering the relay - very low power draw. The power that burns the lights, then, will be coming through the relay on the new circuit.

Just like Troll said- easy...

Posted by Troll

- May 24, 2015, 07:57:51 AM

Start with replacing the bulbs. 55w is WAYYYYYYY too much for the system. This diagram is pretty close to what you should set up. Easy...

Posted by bikerbob5864

- May 24, 2015, 04:36:14 AM

The PO stated that the DL's never worked, or at least sporadically. Well, they're on a two prong rocker switch, one power, the other ground(grounded by the light bases on the bar). The power side was Scotch-locked to red/blu wire in the headlight bucket, no fuses, no relays. Now, I know this is wrong but I'm just not quite sure how to wire up a 5 point relay to this type of switch.
The lamps are running 55W bulbs. Anyone care to walk me thru this? I know to fuse as close to my power source as possible to pin 30 and use 87 as my output, but 85 and 86 stymie me a little since one is a ground.
Any advice and help will be much appreciated.

Bob
PS I HATE scotch-locks too!!!!!!

SMF spam blocked by CleanTalk