Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by chief
 - April 30, 2015, 16:09:59 PM

Don't know what washers you are talking about. I didn't need to add any washers.

On mine... 12 years ago... the seat has a flat plate on the front. That has to fit under the large washer on the bike. Mine wouldn't fit closely enough to allow the L brackets to match the frame holes on the rear.

On mine, I simply took off the washer, ground a bit off, reinstalled and the seat fit nicely - though a bit snug, under it. Over the years, it has gotten a LOT easier to install. The parts apparently grew to like each other.

Posted by moosewing3
 - April 30, 2015, 14:28:36 PM

Hi i purchased a Corbin 2 up and have read a couple of suggestions on how best to install the Corbin, does antone have some pics of these washers I need to use, and how many?

SMF spam blocked by CleanTalk