Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by JagLite
 - February 10, 2015, 10:00:39 AM

Thanks Troll and Bucko, I will be prepared.
I was aware of the fender removal so no surprise there.
I have a Honda VTX1800 so I am used to the lifting challenge.
Crescent wrench? Do they make a metric version?  ;)

Posted by Bucko
 - February 10, 2015, 01:05:23 AM

You'll need to figure out a way to get the rear wheel (or front wheel) off the ground first.

Somebody used to make a easily removable centre stand for the Vulcans, not sure if they're still available or not.

Posted by Troll
 - February 09, 2015, 15:01:38 PM

Ok, so you know. To remove the rear wheel, you have to remove the rear fender...and to do that, you must remove the muffler assy, to gain access to the bolts holding the fender strut on the right side. Not a big deal, but it could take you by surprise...so here's a link to a page on Gadget's forum that will guide you through the rear wheel process: http://www.vulcandrifterriders.com/rearwheelremoval.html.   Take a 10" crescent wrench and a 17 mm 6 point 1/2" drive socket and ratchet with you for the axle removal. The front is easy...You will need an 8 mm long handle Allan wrench for the pinch bolt, that same 10" crescent wrench, and the 12 mm socket set Stan mentions to remove the front wheel. You will also need a #2 phillips screwdriver to take out some screws folding covers....

Posted by JagLite
 - February 08, 2015, 22:44:38 PM

I have only seen pictures of the bike but it looks stock to me:

Posted by Troll
 - February 08, 2015, 15:52:29 PM

I'll answer this question with a question: Do you have a stock exhaust?

Posted by JagLite
 - February 08, 2015, 15:43:10 PM

I am gathering stuff for my fly & ride trip in June and among many projects will be replacing the tires & tubes.
I am putting together a tool kit...
What size wrench(es) do I need for the nuts on the front & rear axles?
(yes I have the standard 8-17mm wrenches & sockets)

Thanks!

SMF spam blocked by CleanTalk