Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by Mike922
 - September 29, 2014, 18:47:52 PM

Thanks, appreciate the comment.  After looking over the bike, seems I should remove the tank and plastic neck covering to access the connectors and wiring, would you agree?

Posted by Troll
 - September 29, 2014, 11:05:56 AM

Look over the wiring. Bad fan is not a common issue, wiring can be

Posted by Mike922
 - September 29, 2014, 11:00:35 AM

In June I installed a new Fan Switch, worked fine up until a month ago.
Now the Fan is not working, I jumped the two connectors and it seems to be blowing the fan fuse.
I was advised to check the fan by adding in an inline 10amp fuse and run off the battery.  If the fuse blows, the fan is bad or going?
Any other ideas on this?  The bike's red warning light came on while at a light, pulled over for a few minutes, then when on open road the light does not come on again.
thank you, Mike

SMF spam blocked by CleanTalk