Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by CDNRatMan
 - August 18, 2014, 16:20:52 PM

I remember thinking it was going to be easy myself last winter. But alas I was told about the forks not having a "drain" plug like my older other bikes had.
I was also told that what Troll has stated is correct, and I could take it all apart, but I did not because it is far beyond my skill set.

Posted by 49Reo
 - August 18, 2014, 15:32:46 PM
Quote from: Troll on August 18, 2014, 05:53:55 AM

Those allan head bolts are the retainers for the damper rods inside the fork, NOT drains. DO NOT REMOVE THEM, THEY HOLD THE WHOLE THING TOGETHER, AND THE FORK SPRINGS WILL THEN PUSH THE LOWERS OFF THE STANCHION TUBES.

That's some good intel there....

Posted by Troll
 - August 18, 2014, 05:53:55 AM

Those allan head bolts are the retainers for the damper rods inside the fork, NOT drains. DO NOT REMOVE THEM, THEY HOLD THE WHOLE THING TOGETHER, AND THE FORK SPRINGS WILL THEN PUSH THE LOWERS OFF THE STANCHION TUBES.   

Posted by Tecumseh
 - August 17, 2014, 23:34:11 PM

You must remove the axle to access the drain plug/bolts that are at the end of the fork tubes. No need to remove the forks and invert them.  :)

SMF spam blocked by CleanTalk