Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by CDNRatMan
 - July 28, 2014, 14:36:19 PM

  I had issues with  really "soft" front forks, I could bottom them out under normal riding and on hard corners it would bounce. I took GreenBarn's advice and went with progressive front fork springs for the 1500. I then used the recommended type and amount of front fork oil and it made a huge difference, and the ride is now really smooth.

Posted by BC
 - July 28, 2014, 14:21:06 PM

Thanks everybody! Nice links there and good info!
I will try a higher grade oil,will 15w or even 20w be enough for my purpose you think?

Posted by pcarrell
 - July 27, 2014, 21:23:29 PM

Tecumseh is right!  A heavier oil is the way to go here!

Posted by Troll
 - July 27, 2014, 18:12:52 PM

No drains. You will have to take them out of the yoke and pop the tops, invert them in a coffee can and wait...

Posted by Tecumseh
 - July 27, 2014, 17:49:19 PM
Quote from: BC on July 27, 2014, 17:33:35 PM

Hi guys,my front fork bottoms really easy,and i was wandering how much i can "overfill" to make it a bit stiffer? Right now its 292mm as by the book.
Measured the springs,and they are well within speccs.So this idea of adding some more oil is just a Quick fix (if it works) im going to put in some progressive springs when the riding season is over. And is there a way to drain the forks from oil,without disassemble the forks?

Over filling will lead to blown fork seals! not a good idea. try a heavier oil.
Posted by BC
 - July 27, 2014, 17:33:35 PM

Hi guys,my front fork bottoms really easy,and i was wandering how much i can "overfill" to make it a bit stiffer? Right now its 292mm as by the book.
Measured the springs,and they are well within speccs.So this idea of adding some more oil is just a Quick fix (if it works) im going to put in some progressive springs when the riding season is over. And is there a way to drain the forks from oil,without disassemble the forks?

SMF spam blocked by CleanTalk