Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by drifter-paul
 - June 12, 2014, 00:00:10 AM

Fitting new rear disk to wheel --

If I use a 8x1.25 mm die to clean loctite off the threads of a bolt, do I then use a 8x1.25mm tap to clean loctite out of the bolt hole ?

The bolt was carefully wound 1/2 way in to the die by fingertips, then finished using the handle . No problems.
However when I used the tap on the holes, i have some fine swerf/swarf (?) although it feeds in smoothly by fingertip then handle.

BUT the newly cleaned bolt feels a little wobbly in the newly cleaned hole. I did (1), and now I' going to wait for an answer. Google & Wiki doen't say, only tap and corresponing drill bit /hole size !!    HELP

SMF spam blocked by CleanTalk