GUEST? Registration opens up many more resources which are not available to guests. Registration is free, we never sell or give others access to your information.
Posted by CDNRatMan
- May 25, 2014, 22:02:20 PMok I just spent the time looking through 3 manuals, and sad to say or I really need new glasses, but there is nothing about removal of the signal lights I could find......
Posted by Troll
- May 25, 2014, 20:13:42 PMIt depends on what year your are working with. The blacked out ones are just a little different from the chromed ones. First, you remove the taillight assy. by removing the three 10mm nuts under the fender, then remove the two special plugs that connect the t'signals to the harness. Might be a good idea to identify which is left/right at this point...Pop off the big rubber cover over the nut on the signal side, and slide it down the wire and off. The plug will fit through, just barely. The signal assy is now loose and easily pulled out and away. The big difference between the black and the chrome is that the chrome ones have a cover over the fender stay that looks like a bumper, and you may feel that it's necessary to remove that, first...2 phillips screws hold them on....
Posted by bhus72
- May 25, 2014, 19:19:03 PMI am taking the originals off and replacing them
Posted by CDNRatMan
- May 25, 2014, 17:55:09 PMAre you taking the original right off, or just replacing a part of them?
They are not that hard to take apart, you will need to get into the tail light to disconnect the harness however.
Posted by pcarrell
- May 25, 2014, 15:29:54 PMThis should help! http://www.ronayers.com/Turn-Signals-C383948.aspx
Posted by bhus72
- May 25, 2014, 15:10:44 PMI need to replace my rear turn signals but cannot figure out how to disassemble them, I feel like there is something small I'm over looking, but as a noob I figured I'd go to the experts. Any advice on the subject would be much appreciated.