We limit access by GUESTS to protect our members from spam, hacks and trolls. Please register to gain access to all our resources.
Posted by jmbo
- April 29, 2014, 06:50:58 AMQuote from: Dubliner - Neville Stewart on April 28, 2014, 21:42:46 PMYes Jmbo, that's more the look I'd prefer. Did you make a cover to go under the seat/ over the battery?
Yes, I made the cover out of metal. I also made a metal cover to fill the gap between the back of the tank and the seat (Not pictured). It makes the seat look more like it belongs on the bike.
Posted by Drift1
- April 29, 2014, 04:43:21 AMDubliner , not sure if JMBO made the battery cover or not , but I do know Singh sells the cover as well .
Posted by Dubliner
- April 28, 2014, 21:42:46 PMYes Jmbo, that's more the look I'd prefer. Did you make a cover to go under the seat/ over the battery?
Posted by jmbo
- April 28, 2014, 21:32:55 PMAttached is a photo of my installation. My seat came with two sets of springs. I used the shorter one and anchored the bottom of the spring to the side of the cast part of the rear frame. Your photo looks like you used a longer spring and it is hard to tell from the photo where the bottom mount is anchored. The combination of a shorter spring and a different mount point should lower the seat and still give plenty of room for fender travel.
Posted by pcarrell
- April 28, 2014, 15:59:13 PMThe rear fender moves with the suspension, quite a bit. I believe you need about 5 1/2 inches clearance.
Posted by Dubliner
- April 28, 2014, 12:43:29 PMRegarding a Singh Spring seat, do they have to sit this high off the bike? THis is a shot of somone elses bike I found on the web, forgive me if theres a problem using it, tx Dubliner