Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by jmbo
 - April 28, 2014, 21:32:55 PM

Attached is a photo of my installation.  My seat came with two sets of springs.  I used the shorter one and anchored the bottom of the spring to the side of the cast part of the rear frame. Your photo looks like you used a longer spring and it is hard to tell from the photo where the bottom mount is anchored.  The combination of a shorter spring and a different mount point should lower the seat and still give plenty of room for fender travel.

Posted by pcarrell
 - April 28, 2014, 15:59:13 PM

The rear fender moves with the suspension, quite a bit.  I believe you need about 5 1/2 inches clearance.

Posted by Dubliner
 - April 28, 2014, 12:43:29 PM

Regarding a Singh Spring seat, do they have to sit this high off the bike? THis is a shot of somone elses bike I found on the web, forgive me if theres a problem using it, tx Dubliner

SMF spam blocked by CleanTalk