Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by CDNRatMan
 - March 04, 2014, 11:20:13 AM

  Mr. Clean Magic Eraser, and or Scrub Daddies and warm water works well for me.....and elbow grease........

Posted by Drift1
 - March 04, 2014, 10:39:00 AM

Page 4 ......titled " cleaning products " should be what your looking for . Milky shine her up good brother , It's almost time to ride for us Northern boys about another month or so ::)

Posted by Milky1112
 - March 04, 2014, 10:16:56 AM

Bahahaha.. I wanna make it purty, PO had it under car port.. so semi exposed (but covered) So gotta make it nice again.

Posted by pcarrell
 - March 04, 2014, 08:17:10 AM

You mean there's non-chrome bits on my bike?  Oh no!  ;)

Posted by Milky1112
 - March 04, 2014, 05:31:43 AM

First off, Mods, sorry if it's in the wrong place.. didn't see anything that fit the bill area wise, and after search didn't find quite what i was searching for, now on the the question...

What's your preferred method of cleaning the non chrome bits.. (Triple tree, lower fork tubes, hand controls and what not) i'm assuming aluminum bits, mine are a bit dingy, not looking to polish (Yet, maybe in the future) but mainly general touch-up. Was thinking some 0000 steel wool would clean some without beating it up too bad. Just hitting up the resident experts in this matter for tips of the trade. Thanks for the help.

SMF spam blocked by CleanTalk