Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by Lupee2u
 - June 30, 2010, 09:20:08 AM

Hi,

I have found that on occassion the bolts on the front fenders need tightening, as well as the screw on the rear portion of the fender. When these loosen it makes a terrible rattling noise when you hit a bump.

Good luck,

Lupee

Posted by Mr Bill
 - June 29, 2010, 09:45:42 AM

I had the same problem(s).
- I wrapped the headlight wires in a shop rag so that they were cushioned and couldn't bounce as much.
- I also put a layer of electrical tape around the inside of the headlight bucket where the bezel (ring) fits in.  This made for a better/tighter fit between the bezel and bucket...no loose slop to rattle.
No more noise :)

Posted by LV2RIDE
 - June 20, 2010, 01:19:37 AM

I checked the windshield, it is clear and not touching anything.. I will be looking into the headlight and slipping a little material in and seeing if that stops it.

Thanks

Posted by jb741
 - June 19, 2010, 21:04:23 PM

I had that same problem with my 1500. Turned out to be a windshield wasn't quite level, and making noise at low speed and bumpy roads....

Posted by chief
 - June 19, 2010, 19:39:56 PM

Also, the headlight ring on Drifters sometimes rattle. Make sure its secure and tight.

Posted by LV2RIDE
 - June 19, 2010, 19:38:12 PM

Thanks, I will try that. Sounds like an easy fix.   This is a great forum, so many great people willing to help others and give good advice.

Posted by Hoppy
 - June 19, 2010, 07:54:55 AM

Most likely it's the wiring bundle bouncing around inside the headlight bucket. Easy fix is to line the bucket inside with an old mousepad or layer of foam or even an old sweatshirt that has been cut up. This is a common complaint for the drifter and an easy fix.
Hoppy

Posted by LV2RIDE
 - June 19, 2010, 00:47:36 AM

I am the proud owner of a 2001 Drifter, however I am getting a noise (rattle) sound from the front of the bike? I have adjusted the windshield to make sure it is NOT touching any brackets. It sounds like the headlight has ball bearings in it but only when I go over a bump or a vibration at low speed...strange?? Anyone else had this problem??

Thanks
Larry

SMF spam blocked by CleanTalk