Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by DC
 - September 24, 2013, 10:58:01 AM

Is 17k a hard number or is it dependent on riding conditions?

Posted by capnconch
 - September 24, 2013, 09:32:48 AM

Maybe I should rephrase and modify my question;  Who actually has had this service done either by themselves or at the dealer or cycle shop?

Am I the only negligent owner here?
BTW, I'm not really negligent in all other areas of my Drifters maintenance just in this particular area, and no I haven't tackled the job yet. Daily Monsoon rains continue here in SW Florida so I haven't been riding either.
Posted by Troll
 - September 20, 2013, 15:24:23 PM

I have, and I replaced my U-Joint, too. I have lubed my swing arm bearings, greased the drive spline where it goes into the rear wheel...lots of stuff. Just takes time, it's not rocket surgery, just nuts and bolts. The hardest part of this whole thing is getting the bike so it's stable enough to do the work with the rear wheel off the ground. I did a write up on replacing the bevel drive housing last month...again, no big deal. I believe it's posted under mods and tips....

Posted by capnconch
 - September 20, 2013, 10:27:41 AM

I just flipped 17,000 mi on my  Drifter 1500 and I have read Gadget's Lube your driveshaft instructions for years. I refuse to go to dealer to do this but I keep putting it off.
How many of you out there have actually done this procedure?
Or do you really trust your dealer or bike shop to do it and hope they do it right.
I AM GOING TO DO IT!. To Harbor Freight today to get the circlip pliers, time to get down and dirty.
But who else has done it themselves..Show of hands please and if you don't mind, tell of any obstacles you may have encountered.

I successfully lowered my front fork springs 1 " Progressive springs, without removing the forks!!! (bent wire coat hanger to fish out the stock springs and stuff out.) Will write an article on this shortly.

Conch

SMF spam blocked by CleanTalk