Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by chief
 - September 14, 2013, 11:32:54 AM

Check the wiring at the clutch grip... there is an interlock switch there that must be connected ... sometimes its not fully seated.

Check the lever adjustment.

Make sure you reconnected everything properly when you replaced the bars.

Are you getting any pressure when pulling the lever?

Posted by vulcan_bare_bone
 - September 13, 2013, 16:51:23 PM

Hello fellow drifters!

I am having a problem with the clutch on my 1999 Drifter 1500.  I recently changed the handlebars and grips, and now the clutch will not disengage. It starts and runs fine in neutral, however as soon as I put the bike in gear, it jumps and stalls as if I have not pulled the clutch lever in.
The funny part, is that it was working just fine 1 hour before I changed the bars and grips. I originally thought that the problem was due to air in the line (since I had the master cylinder hanging upside down while changing the bars). However, I have bled the line from the master cylinder end, as well as from the slave cylinder end... no success!

Any suggestions would be greatly appreciated!

SMF spam blocked by CleanTalk