Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by draconarmy
 - August 31, 2013, 18:03:47 PM

like i said its more of a band-aid than a fix.... so can anyone recomend an aftermarket replacement that wont take away from the vintage look?

Posted by Troll
 - August 31, 2013, 17:47:38 PM

The body of the cylinder is not available separately. Pretty sure all the VN1500 clutch cylinders are the same. There are a few on eBay...You should not rely on JB weld, but rather REAL welding to fix this part, but you will then need a $40 kit to rebuild it, since the heat will destroy the rubber parts...

Posted by draconarmy
 - August 31, 2013, 15:43:50 PM

here is a picture of the actual damage

Posted by draconarmy
 - August 31, 2013, 15:35:59 PM

ok so while doing an inspection on my bike I noticed some vertical play on my clutch lever.  upon further inspection I foud it was due to a break underneath the lever on the master cylinder housing (circled in red below).  I would rather not replace the entire unit if I can get just the piece circled in yellow but I don't see a part number for just it?  also can I get by until that part comes in with just some JB weld?

SMF spam blocked by CleanTalk