Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by Bucko
 - July 12, 2013, 19:21:41 PM

I put about a 200 Km's on last Saturday and 20 or 30 or so last night.  Can't remember the last time I chedked the coolant but it would have been last summer when I had it out last.

Oil sample looks pretty clean.

I'm not smelling anything so I don't think I'm burning it.

Thee are definitely no leaks while sitting as I park it on a clean garage floor and I'd notice the drips right away if there were any.  I guess thee could be leaks while it's running (never in the garage)  In any case I'll take a closer look.

My theory at this point is that when I last changed the coolant - summer before last I think - I'll have to check my records. I maybe never got all the air out - me not paying much attention to purging and all -   and over the course of riding it, gradually purged the air out and the overflow tank gradually emptied.  I didn't drive it much last summer.

Posted by John Hopkins
 - July 12, 2013, 15:08:19 PM

You say you just got back from a ride, but you don't say how far..You also say you got the bike out of winter storage last week but don't say if you have been riding it all week..

without further knowledge I suggest you drain all the old oil out, remove the old oil filter, drain and flush the coolant system and examine all the waste liquids for cross contamination..

Many people think that because these engines are so large, that they are indestructable..they are not..

Coolant is the single most important part of your engine..

Before you remove all the fluids from your engine lay down beside the bike with some kitchen towel and wipe all around and under the engine to find any wet spots..if you find any carefully trace them upwards until you are sure you have located the source, then replace the part that is causing the leak before refilling the fluids.

don't undo a single nut or bolt until you have taken a clear photo of it because this will save you wondering where that pipe or wire or cover went.

John.

Posted by Troll
 - July 12, 2013, 12:11:10 PM

If it's burning coolant you will know it pretty quickly. Very distinctive smell in the exhaust, even without white smoke. I would monitor it over the next few days. Are you sure there are no external leaks?

Posted by Bucko
 - July 12, 2013, 11:39:16 AM

I got back from a ride last night and happened to notice the coolant looked low so I removed the right hand side cover to discover the overflow bottle was completely empty.  What the ^&%$?  My experience over the years is that I often have to ad a bit of coolant after the bike has sat over the winter (I just got the bike out of storage last weekend) but this is the first time that the bottle was empty.  In any case, I filled the bottle to the full level, then checked this morning (after cooling overnight) and some of the fluid has been sucked back in to the cooling system as it should.

Just wondering if i need to go through the full burping process once the bottle has gone dry?  I usually don't get overly concerned about burping as the cooling system will generally self purge over a number of hot/cold cycles as long as the bottle is topped up and as long as there's minimal air in the system to begin with.

Still wondering where that coolant went though.  I don't smell anything odd in the exhaust and no sign of leaks. Oil Looks fine. ?????  I hope it's not being sucked into the cylinders.

Comments?

SMF spam blocked by CleanTalk