GUEST? Registration opens up many more resources which are not available to guests. Registration is free, we never sell or give others access to your information.
By the numbers:
1) Bike in neutral
2) Ignition switch ON
3) Confirm neutral light
4) Oil pressure light, temp, FI, Fuel on momentarily then off
5) Set STOP switch to run/on
6) Hit start button...
CHECK THE CLUTCH SWITCH ON THE HANDLEBARS... if that little switch is loose or disconnected you will get the click thing when trying to start. If that is NOT the problem...
7) ECU fault test.If FI ok...
Check fuses
9) Double check battery... I had a brand NEW battery that was bad.
10) You had starter and relay checked... as ok.
So... could be:
11) seized pistons
12) seized crankshaft bearings
13) broken connecting rod
14) locked up transmission or clutch
15) defective starter clutch.
Hi all, received this message this am from "luckyluck. Anyone have any advice for this person?
1500 VULCAN WON'T STARTReplyReply
Reply with quoteQuote
Remove this messageRemove
I REPLACED THE BATTERY ,REPLACED THE SOLENOID RELAY, HAD THE STARTER CHECKED. ALL I HEAR IS A LOW CLICK SEVERAL TIMES AND THEN NOTHING . PLEASE TELL ME WHAT IS GOING ON. THANKS
Page created in 0.083 seconds with 12 queries.